RinoGear - Samsung Galaxy Note 9 Screen Protector Wet Installation

RinoGear - Samsung Galaxy Note 9 Screen Protector Wet Installation. #Samsung Note 9 - #ZAGG Glass Curve Application

RinoGear - Samsung Galaxy Note 9 Screen Protector Wet Installation video duration 15 Minute(s) 42 Second(s), published by RinoGear on 09 10 2018 - 04:22:03.

Buy on Amazon: https://amzn.to/2QJ7giA *** Written Instructions Below *** PLEASE READ: Watch the video if installing for the first time
It will take 1-2 days for The Best screen protector for Galaxy Note9 Click below to purchase http://amzn.to/2FMFeB5 visit our website to see more info - www.whitestonedome.com.

Read our written review with more still image samples and waffle: https://www.all-things-photography.com/blog/samsung-galaxy-note-9-review So how does the Here are the top 5 BEST cases you can get for the Samsung Galaxy Note 9! I have the best slim case, the best medium sized case, the best rugged case, the Quick application steps on the ZAGG Glass Curve screen protector for the new Samsung Galaxy Note 9
Also, briefly go over the limited warranty ZAGG offers!

Buy on Amazon: https://amzn.to/2QJ7giA

*** Written Instructions Below ***

PLEASE READ: Watch the video if installing for the first time. It will take 1-2 days for the haziness and micro-bubbles from the installation to disappear. This is normal. Imperfections will disappear as the film settles.

CAUTION: Even though the film generally dries after a couple of hours, as a precaution, please allow a full 8 hours of dry time before powering on the device.

Step 1: Remove the battery from the device. If your device does not have a removable battery, have it power off if possible. Add a drop (about 1/2 tsp.) of liquid dishwashing soap to one cup of water and stir. This mild solution will be used to position the film(s) on the device. Thoroughly clean surfaces to be covered. TIP: You can also mix this solution in a spray bottle if you have one available.

Step 2: With clean hands, soak your fingers into the soapy solution so that you do not leave fingerprints while handling the film(s). With wet fingers, peel off the backing paper from the film, exposing the adhesive side. Dip the entire film into the solution or spray it generously if using a spray bottle, wetting it completely. Hold the film up and gently shake off excess dripping water. The film should now be moist, but not dripping wet.

Step 3: Align and apply the film unto the surface of your device. Softly squeegee out the liquid solution and use a cloth to soak up any excess moisture. A credit card can also be used as a larger squeegee.

**NOTE: The film will begin to adhere to the surface as the water is squeegeed out and will no longer slide freely on the surface. If the film is not aligned correctly, remove it and start Step 2 over.

Step 4: Allow the film to dry at least 3 hours before powering the device. Micro-bubbles should disappear in the next few days.

TIP: When applying the film on a curved edge, allow the overhanging portion of the film to dry a bit until it can properly adhere to the surface. Just remember that the film adheres more when it is drier.